Bergan Manual Gauging System

Bergan Manual Gauging System

The manual gauging system uses ...................

  • Manual gauging, no electrical connection required.
  • Intense coloring or visual reference.
  • Accurate, based on tank dimensions.
  • Meets CFR visual requirements.
  • Visual gauge tree built for the life of the vessel.
  • No Maintenance required.
  • Easy installation.
Bergan Blue Electro Pneumatic Control Panel

System Details

Approved

ABS, DNV, LR, GL, BV

Categories
Level Gauging
Vessels
  • Tank Barges
  • Ocean Tank Barges
  • Tank Ships
  • Offshore Vessels

Bergan Manual Gauging System

Manual Gauging

The gauging method is the simplest application you can install on tanks, not requiring cable runs.. This is normally through a GuardLevel®Sight Glass and gauge tree. The sight glasses are mounted on the top of the tank dome. Below the sight glass is a Visual Gauge tree.

The Gauge tree has level flags (innage/Ullage) at 6” increments annotating a level measurement. The sight glass has a hinged lid that the user opens to view through the glass the level of product in the tank. As the level rises it reaches a gauge tree flag and indicators product level.

Another manual method is a rising gauge stick or the GuardLevel®MDS (Magnetically Coupled Gauge Stick).

This float-based unit has a float attached to a 1” pipe. Inside the pipe is a tri-colored wand normal 1 meter in length. Attached at the bottom of the wand is a magnet. The top of the unit has a screw cap. The user removes the screw cap allowing the wand to rise with the magnet for a visual indication when the cargo is 1 meter or less from the top of the tank.

The top of the wand is colored Green indicating all well; the middle is Yellow indicating warning cargo is nearing overfill status; the bottom is Red indicating a possible overfill condition. Once the load is complete, the user disengages wand with float and lowers wand into unit, and screws cap back on.